Pulsafeeder Pulsa GLM DM1-6 - Manual (Page 19)

15
5. Replacement Parts
5.1 KOPkit Program
PULSA GLM ® KOPkits contain all replacement parts normally used in a preventative maintenance
program. (PULSAlube is also available separately for preventative maintenance programs. Refer to
Section 3 – Equipment Startup). There is a specific KOPkit for every PULSA GLM
® pump model.
Each KOPkit is vacuum-packed for extended storage. All PULSA GLM ® pumps have the KOPkit number
identified on the pump nameplate and Pulsafeeder order documents. KOPkits can also be selected from
the technical data sheet shipped with the pump or by a Pulsafeeder representative. A list of the PULSA
GLM KOPkit numbers can also be found on the next page. The kit is identified by the model number of
the pump, the wetted end material, and the process connection thread type. For models with tie-bar type
check valves, the appropriate components (check valve balls, seats, and o-rings) are supplied instead of
the cartridges pictured.
5.2 Ordering KOPkits or Parts
When ordering replacement parts always specify:
• Pump model and serial number (from pump nameplate), e.g., Model No. (M2) with
Serial No. F406365-3.
Figure 19: PULSA GLM® Nameplate
• Part number and description from the PULSA GLM ® parts list. Include the three-character suffix.
(Note: PULSA GLM part numbers begin either with the letters NP, or the letter W, e.g., NP170001-
THY or W210221-001.)