Balboa Water Group Revolution - Manual (Page 95)

Revolution
Transforming the Control of Hot Tubs
95
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,
834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
Mounting
Revolution technology allows mounting flexibility. The Revolution can be t
mounted on either the suction or pressure (discharge) side of the pump.
However, it must be mounted on a flat surface parallel to the ground.
To improve reliability, take steps to t minimize vibration from the pump(s) that
could be transmitted to the Revolution.
Use t rubber isolation pads under the pumps and flexible PVC between the
filtration pump and the heater to help minimize vibration.
Mount the system with the heater horizontal and as low as possible in the t
equipment compartment.
To avoid any potential for water to drip directly on the system, do not mount t
the system directly under the control panel mounting location.
Allow a t drip-loop in the control panel wires to keep any water that may travel
down the wire from wicking onto the system box.
The Revolution can not be mounted upside down. The Revolution is not to t
be mounted sideways. The Revolution is only to be mounted upright on a
flat horizontal surface.