Balboa Water Group Revolution - Manual (Page 25)

Revolution
Transforming the Control of Hot Tubs
25
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,
834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
Priming Mode
Press to Start Pump 1 at Low Speed
Press Again to Switch to High Speed
Press to Start Pump 2
Priming Mode
Press the JETS button once to start Pump 1 in low speed t
Press again to switch to high speed t
Press the AUX button to turn on Pump 2, if available. Be sure that the 2nd t
pump is energized.
The pumps will now be running at high speed to assist priming. t
!
IMPORTANT
A pump should not be allowed to run without priming for more than 2 minutes.
Under NO circumstances should a pump be allowed to run without priming
beyond the end of the 4 - 5 minute priming mode. Doing so may cause damage
to the pump and cause the system to energize the heater and go into an
overheat condition.