Balboa Water Group Revolution - Manual (Page 17)

Revolution
Transforming the Control of Hot Tubs
17
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417,
834 b2, Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
Topside Panel Installation (cont.)
The topside panel is specifically designed to withstand the harsh spa
environment and is intended to be mounted in a location on, or close to the spa,
in order to provide the spa user with the greatest convenience when controlling
the spa equipment.
Cut a mounting hole as shown. (A more detailed view is shown on the 1.
following page.)
Fit the topside panel into the hole to make sure the hole is the proper size 2.
before proceeding.
Remove all dust and particles from the mounting surface around the hole. A 3.
clean smooth surface that is dry and oil free is required for the adhesive on
the back of the panel to attain a good bond.
Remove the paper backing from the adhesive on the rear of the panel. All of 4.
the adhesive should be exposed.
Route the connecting cable through the opening and place the topside 5.
panel into the opening. Align the panel and press firmly onto the mounting
surface. Route the cable to the control system.
Remove the top cover to the control system, and remove the cable retaining 6.
clamp.
Plug the 7. cable connector into the connector labeled J33. Replace the
connector clamp and secure the screw.
Drill a .5” hole on the kerf of the center hole.
This will clear chips from the hole saw and
speed the drilling of the first (center) hole.
2.5” hole saw for each overlapping hole.
Pilot hole locations for optional fasteners.
1
2
3
1.7” 1.7”
7.125”
3.5”
C/L
Pilot hole locations for optional fasteners
Center to Center Center to Center
rill a .5 hole on the kerf of
e center hole.
his will clear chips from the hole saw
nd speed the drilling of
e first (center) hole.
2.5” Hole S
each overl