Apollo 150 - Manual (Page 166)

User Manual version 2207
APOLLO 120/150 III 9-156
9.2.3. Installation
This section details the installation procedures for the
software on the DOS and Windows Driver Disk. Four steps
are required:
Step 1 Configuring the touchscreen controller
Step 2 Installing the controller
Step 3 Running the INSTALL program
Step 4 Calibrating the touchscreen
S
TEP
1 - C
ONFIGURING THE
T
OUCHSCREEN
C
ONTROLLER
THE MANUFACTURER ships most touchscreen controllers
preconfigured for use with Elo software.
S
TEP
2 - I
NSTALLING THE
C
ONTROLLER
If you need help when installing the touchscreen controller or
making the connections, please contact the Manufacturer’s
Customer Service department.
S
TEP
3 - R
UNNING THE
INSTALL P
ROGRAM
The DOS and Windows Driver Disk contains an installation
program which will automatically transfer all necessary files
to the hard disk.
If you intend to install the Windows drivers, make sure that
the Windows has been installed and operating properly
before proceeding. You must have a DOS mouse driver
(MOUSE.COM) installed for your mouse if you wish to
continue using your mouse along with the touchscreen in
DOS or Windows.
If you only want to change the configuration of your
touchscreen controller, see Changing Your Hardware
Configuration with SETUP, page 14, for information on the
SETUP utility.