Hellenbrand H-125 Series - Manual (Page 24)

24
Drive Cap asseMblY, DOWn flOW pisTOn, reGeneranT pisTOn anD
spaCer sTaCk asseMblY
3
2
4b
4a
6
5
1
7
8
4
1 151-V3430 H125 Spacer Stack Assembly 1
2 15-V3004 Drive Cap Assembly 1
3 15-V3343 H125 Drive Back Plate 1
4 151-V3407 H125 Piston Downflow Assy 1
5 15-V3174 Regenerant Piston 1
6 15-V3135 O-ring 228 1
7 15-V3180 O-ring 337 1
8 151-V3358 O-ring 219 (Dist. Tube Opening 1.32") 1
QUANTITY DRAWING NO. ORDER NO. DESCRIPTION
Note: The regenerant piston is not used in backwash only application.
inJeCTOr Cap, inJeCTOr sCreen, inJeCTOr, pluG anD O-rinG
1 15-V3176 Injector Cap 1
2 15-V3152 O-ring 135 1
3 15-V3177 Injector Screen 1
4 15-V3010-1z Injector Assembly z Plug 1
15-V3010-1A Injector Assembly A Black
15-V3010-1B Injector Assembly B Brown
15-V3010-1C Injector Assembly C Violet
15-V3010-1D Injector Assembly D Red
15-V3010-1E Injector Assembly E White
5 15-V3010-1F Injector Assembly F Blue 1
15-V3010-1G Injector Assembly G Yellow
15-V3010-1H Injector Assembly H Green
15-V3010-1I Injector Assembly I Orange
15-V3010-1J Injector Assembly J Light Blue
15-V3010-1K Injector Assembly K Light Green
Not Shown 15-V3170 O-ring 011
Not Shown 15-V3171 O-ring 013
QUANTITY DRAWING NO. ORDER NO. DESCRIPTION
*The injector plug and the injector each contain one 011 (lower) and 013 (upper) o-ring.
Note: For upflow position, injector is located in the up hole and injector plug is in the
other hole. H125 upflow bodies are identified by having the DN marking removed. For
a filter that ony backwashes, injector plugs are located in both holes.




