ADTRAN ISU 128 - Manual (Page 38)

61202.029L2-1 ISU 128 User Manual 23
Chapter 6
Configuration
DIAL LINE OPERATION
This section explains how to configure the ISU 128 when using ISDN basic rate
switched service. Figure 6-3 illustrates the entire CONFIG branch of the menu
tree.
The following are step-by-step procedures for configuring the unit for dial line
operation, switch protocol, call type, terminal ID, dial options, auto answer,
answer tone, connect timeout, and call screening.
To dial calls over the ISDN, the unit must be configured for Dial Line. The
menu path to select Dial line operation is shown in Figure 6-1.
Figure 6-1
Dial Line Menu Tree
When using a VT 100 terminal, press Ctl-C to access the Configuration screen,
then set the Line type option to Dial Line. The Configuration screen appears
as shown in Figure 6-2.
3=CONFIG
1=Netw. options
2=DTE options
3=Protocol
4=Quick setup
5=Remote config
1=Dial Line
2=Leased Line