ADTRAN ISU 128 User Manual
Page 113
Appendix C. Status Buffer Messages
98
ISU 128 User Manual
61202.029L2-1
BAD_INFO_ELEM
Call control error.
Bad phone number
ISU 128 attempted to call an invalid phone number.
Bad TLK Version
Invalid TLINK parameters found during end-to-end negotiations.
BaudRate
ISU 128 does not support the negotiated TLINK baud rate.
BEAR_CAP_NOT_AVAIL
The bearer channel requested by the user is not available.
Bearer mode
Incoming call is not of a type the ISU128 can accept.
Bearer info mode
Incoming call information transfer capability is not known.
BONDING (+/- XXX)
The amount of bytes of corrected delay between the B2 and B1 bearer channels
(XXX can range from -8000 to +8128 bytes).
BPS mismatch
Bonding negotiation found a bit rate mismatch.
Break to AT cmd
User issued a break-in request (+++).
Break ignored
User issued an extra break-in request.
BUSY
The called number is busy.
CallID 1 in use
ISU 128 tried to place a call using SPID 1 though SPID 1 was already in use.
CallID 2 in use
ISU 128 tried to place a call using SPID 2 though SPID 2 was already in use.