Sony ICD-SX712D - Manual (Page 140)

140 GB
Message List
Message Cause/Remedy
HOLD • All the button operations are disabled because the IC recorder is in
the HOLD status to prevent unintentional operations. Slide the
POWER/HOLD switch towards the center to release the IC
recorder from the HOLD status (page 11).
Low Battery • Batteries are exhausted. Replace the old LR03 (size AAA)
alkaline batteries with new ones. Or charge the rechargeable
batteries (page 12) or replace the old rechargeable batteries with
new ones.
Memory Card Error • An error occurred while a memory card was being inserted into
the memory card slot. Remove and try inserting it again. If this
message persists, use a new memory card.
Memory Card Not Supported • A memory card that the IC recorder does not support is inserted.
See “About compatible memory cards” on page 47.
Unknown Memory Card • An M2™ that the IC recorder does not authorize is inserted. See
“About compatible memory cards” on page 47.
Memory Card Locked • The memory card is write-protected. A write-protected memory
card cannot be used with the IC recorder.
Read Only Memory Card • A read-only memory card is inserted. A read-only memory card
cannot be used with the IC recorder.
Memory Card Access
Denied • Since a memory card containing an access control function is
inserted, you cannot use it.
Memory Full • The remaining memory capacity of the IC recorder is insufficient.
Erase some files before recording.