Asante Technologies FR3000 Series User Manual
Page 78
78 Asanté FriendlyNET Cable/DSL Router
F.5 PPTP Log
Instead of PPPoE, some ISPs adopt Point to Point Tunneling Protocol (PPTP) to
provide their services. PPTP is defined in RFC 2637.
1.
“PPTP start to dial-up”.
PPTP task of the router starts to dial-up.
2.
“PPTP server=10.0.0.138 CONNECTION_ID”.
The router intended to establish a connection to the PPTP server whose IP ad-
dress is 10.0.0.138 and the “Connection ID” is CONNECTION_ID. If the
“Connection ID” is not well configured, you may get error –304 or –333.
3.
“Connection is broken”.
The connection is abnormally broken. The router has no choice but terminate the
session immediately. The reason may be:
•
PPTP control connection is terminated abnormally
•
No replied received when the router probes the WAN connection
4.
“PPTP start to hang-up”.
The router starts to hang-up its PPTP session.
5.
“PPTP:error= ERROR_NO”.
An error occurs on PPTP control connection. Currently, there are following er-
rors:
Error
Cause
-111
PPTP server is unreachable. Check configuration!
-112, -115
Fail to establish connection to PPTP server.
-200, -214, -299
PPTP control connection was aborted abnormally
-301, -302
PPTP server rejects connection request.
-312
Command channel not established—general error
-313
Command channel already exists.
-314
Requester is not authorized to establish a command channel.
-315
The protocol version of the requester is not supported.