Sony RM-NU1 - Manual (Page 18)

18 GB
Basic operations
Charging the unit
This unit is not fully charged when you first
unpack it after purchase. Make sure to fully charge
the unit before using it.
1
Connect one end of the AC power
adaptor to the DC IN jack of the
remote control charger and the
other end to a wall outlet.
2
Place the unit on the remote
control charger.
When you place the unit on the remote
control charger, the CHG indicator lights up
in red and charging starts.
The CHG indicator turns off when the unit is
fully charged.
Turning this unit on/off
Slide the ?/1 (power) switch in the
direction of the arrow.
The last screen which was used when you used this
unit the last time appears.
The screen goes off automatically if you do not
operate this unit for a while (standby mode). In this
case, press any button on the unit or tap the screen
to turn the screen on again.
Note
This unit is turned off automatically if you do not operate
this unit for certain period of time (standby mode). In this
case, tap the screen, press any button on the unit, or slide
the ?/1 switch in the direction of the arrow to turn it back
on. It takes a while to reboot.
To enter the standby mode
Set the unit to the standby mode when you are not
using it.
The standby mode makes the time shorter that
required for fully charging the unit on the remote
control charger than that required when the unit is
turned off.
Slide the ?/1 switch in the direction of
the arrow when the unit is turned on.
To boot up the unit, tap the display window or
press any button.