Nikon P7100 - Manual (Page 43)

25
Step 1 Turn the Camera On
Th
e
Bas
ics of Shoo
ting and
Pl
a
y
b
a
ck
Turning the Camera On and Off
• When the camera is turned on, the power-on lamp (green) lights and the
monitor is turned on (the power-on lamp turns off when the monitor is turned
on).
• To turn off the camera, press the power switch. Both the monitor and the
power-on lamp are turned off.
• To turn on the camera in playback mode, press and hold the c (playback)
button. At this time, the lens does not extend.
C
Power Saving Function (Auto Off)
If no operations are performed for a while, the monitor will turn off, the camera will enter standby
mode, and the power-on lamp will blink. If no operations are performed for another three minutes,
the camera will turn off automatically.
To turn on the monitor again in standby mode, perform either one of the following operations.
• Press the power switch, shutter-release button or the c button.
• Rotate the mode dial.
• The time that elapses before the camera enters standby mode can be changed using the Auto off
setting in the setup menu ( A104).
• By default, the camera enters standby mode in about one minute when you are using shooting
mode or playback mode.
• If you are using the optional AC Adapter EH-5b, the camera enters standby mode after 30 minutes.
This setting cannot be changed.
1/250 1/250 1/250 38 38 F5.6 F5.6 F5.6 38
Blinks
No operations
performed.
No operations
performed.
3 min
Camera enters
standby mode.
Camera turns off.