Troubleshooting/repair – Nikon Forestry User Manual
Page 16
30
Ru
Se
Nl
Dk
Pl
Hu
Cz
Fi
No
En
De
Fr
Es
It
Ro
31
Ru
Se
Nl
Dk
Pl
Hu
Cz
Fi
No
En
De
Fr
Es
It
Ro
Troubleshooting/Repair
If your Nikon Laser Forestry Pro should require repair, please contact your local dealer for details regarding
where to send it. Before doing so, you are advised to consult the Troubleshooting Table below.
Symptom
Check Points
Unit does not turn
on — LCD fails to
illuminate
Target range cannot
be obtained
[- - -] (“Cannot
measure”) appears
Closer target cannot
be measured
Target beyond a
certain distance
cannot be measured
• Depress POWER button.
• Check and replace batteries if necessary.
• Be sure that nothing, such as your hand or finger, is
blocking the laser emission aperture and laser detector.
• Be sure that the laser emission aperture and laser detector
are clean. Clean them if necessary.
• Be sure that the target shape and condition is appropriate
to reflect the laser beam.
• Replace battery.
• Be sure to hold the unit steady while depressing the
POWER button.
• Be sure the target is within measuring range (10-500m/11-
550 yards/33-999 feet)
• Be sure that nothing, such as leaves or grass, is between
the Nikon Laser Forestry Pro and the target.
• Be sure that nothing, such as leaves or grass, is between
the Nikon Laser Forestry Pro and the target.
If problems persist after consulting the Troubleshooting Table, please contact your local dealer to check/repair the Nikon
Laser Forestry Pro. Never let anyone than the official representative of the product manufacturer check or repair the Nikon
Laser Forestry Pro. Failure to follow this instruction could result in injury, or damage to the product.
Symptom
Check Points
Measurement result is
unstable
Incorrect result is
displayed
• Replace battery.
• Be sure that the target shape and condition is appropriate
to reflect the laser beam.
• Be sure to hold the unit steady while depressing the
POWER button.
• Be sure that nothing, such as leaves or grass, is between
the Nikon Laser Forestry Pro and the target.
• Replace battery.
• Be sure that the target shape and condition is appropriate
to reflect the laser beam.
• Be sure that nothing, such as leaves or grass, is between
the Nikon Laser Forestry Pro and the target.