Nikon Forestry - Manual (Page 12)

22
Ru
Se
Nl
Dk
Pl
Hu
Cz
Fi
No
En
De
Fr
Es
It
Ro
23
Ru
Se
Nl
Dk
Pl
Hu
Cz
Fi
No
En
De
Fr
Es
It
Ro
【1 • 2】 Power On/Off and mode settings
Operation and internal display
Operation/Results Work Button Display
Display
examples
1
Power On
Measurement standby
Initial screen POWER
All symbols
(while pressing)
Measurement standby Last Use mode symbol
2 Selecting and setting modes
(1) Linear distance 【3】 n/a
(2) Horizontal distance 【4】 MODE n/a
(3) Height (from horizontal)【5】 MODE n/a
(4) Angle (from horizontal)【6】 MODE n/a
(5)
Vertical separation
(height between two points)【7】
MODE
blinks
n/a
(6)
Three-point measurement 【8】
(height between two points)
MODE
blinks
n/a
Return to 2-(1) Linear distance, then repeat. n/a
See the relevant section in this manual for each mode setting and display.
9 Power off
Regardless of process, after 30 seconds since your
last operation, power turns off.
30 seconds
without
operation
【3】 Linear distance mode
Operation/Results Work Button Display
Display examples
meter yards feet
Elevation (˚) Depression (˚)
3 Measurement with Linear distance mode
3-1
Seeking your target
(Align the reticle with target)
Linear distance
3-2
Measurement
(Laser irradiate symbol is
displayed.)
With the POWER button depressed,
continuous measurement is possible for
up to 20 seconds.
(When done, 3-3 display appears.)
POWER
3-3 Failure to measure Repeat step 3-1.
3-4 Measurement OK
Linear distance
Follow by 3-1.
206 225
9 Power off
Regardless of process, after 30 seconds
since your last operation, power turns off.
30 seconds
without
operation