Spektrum SPMAR12120 User Manual
Page 20
EN
20
Problem
Possible Cause
Solution
The system will
not connect
Your transmitter and
receiver are too close
together. They should be
8 to 12 feet apart
Move transmitter 8 to 12 feet
from receiver
You are around metal
objects
Move to an area with less
metal
Model selected is not the
model bound to
Check model selected and
ensure you are bound to
that model
Your transmitter was
accidentally put into bind
mode and is not bound to
your receiver anymore
Rebind your transmitter and
receiver
Receiver quits
responding during
operation
Inadequate battery voltage
Charge batteries. Spektrum
receivers require at least
3.5V to operate. An inad-
equate power supply can
allow voltage to momentarily
drop below 3.5V and cause
the receiver to brown out and
reconnect
Loose or damaged wires
or connectors between
battery and receiver
Check the wires and con-
nection between battery and
receiver. Repair or replace
wires and/or connectors
Receiver loses
its bind
Transmitter stand or tray
could be depressing the
bind button
If stand is depressing bind
button, remove from stand
and rebind
Bind button pressed be-
fore transmitter turned on
Rebind your system follow-
ing binding instructions
Receiver blinking
at landing
System turned on and
connected then receiver
turned off without turning
off transmitter
Turn off transmitter when
receiver is turned off