Spektrum SPM2020 DX2 - Manual (Page 16)

16
The DX2 allows a three-character name to be input for each of the two (2) models available.
The current model, with name, will then be displayed in the Normal display screen. This
feature is useful to help identify different models, setups, etc. For information on selecting
models 1 or 2, please refer to the Model Select Function (page 19).
Accessing the Model Name Entry Function
To access the Model Name Entry function, follow the steps below:
Press and hold the MODE and
CHANNEL keys at the same time
to enter the System Mode
MODE CHANNEL
ENTER
SYSTEM
Press the CHANNEL key to
select the character to be changed
Press the INCREASE or
DECREASE keys to select the
correct letter/number to be used
INCREASE DECREASE
CLEAR
DIRECT
+ –
1. Press the MODE and CHANNEL keys at the same time and hold.
2. Turn on the transmitter power switch to enter the System Mode.
3. MD1 should now be present on the screen.
4. Press the
INCREASE or DECREASE keys to select the correct letter/number for the
first character (flashing).
5. To change the remaining two characters, press the CHANNEL key until the desired
character to be changed is flashing.
6. To access the Data Reset function, press the MODE key. To exit the System Mode,
either turn the transmitter power switch off or press the MODE and CHANNEL keys at
the same time.
Model Name
Entry
(System Mode)
md1
1
Flashing character indicates
the character to be adjusted
Current Model Number
- -