Swiftech MCW60 GT200 - Manual

Copyright Swiftech 2008 – All rights reserved – Last revision date: 9-11-08
Rouchon Industries, Inc., dba Swiftech – 3400 Industry ave, suite 104, CA 90712 – Tel. 562-595-8009 – Fax 562-595-8769
E Mail: Swiftech @swiftech.com – URL:
http://www.swiftech.com
GT200 Adapter plate for MCW60
Installation Guide
Item # Part # Description Quantity
1 2-56x7/8" Philips Screw 4
2 MCW60-GT200 HDP Hold-down Plate 1
3 6-32x3/8 socket Screws n/a
4 15TSB056B Tapped nylon spacer 4
5 GT200 VGA Graphics Card n/a
6 GT200 VGA Back plate n/a
7 77706 2-56 Thumb nut 4
1
2
3
4
5
6
7
8
8 Tolerance washer 4
1. Remove the existing hold-down plate from the MCW60 by loosening the (4) socket screws #3, and
replace it with the provided GT200 adapter plate.
2. Insert the (4) provided Philips screws #1 into the mounting holes of the hold-down plate, and fasten
them to the plate with the (4) provided threaded nylon spacers #4
3. Clean the GPU surface from old thermal compound with alcohol or an electronics degreaser, and
apply the equivalent of a little mound of the provided Arctic Céramique Thermal compound
Information subject to change without notice