Swiftech MCW6000 P User Manual
Parts list

1.
Preparing your Motherboard
Remove the existing heat sink
Carefully clean the CPU.
Lightly coat the CPU with thermal compound. We recommend high quality thermal compound such as Arctic Silver or
equivalent.
2.
Water-block orientation
For ease of operations during bleeding, the outlet should always be at the highest point (while system is standing upright):
Parts list
Parts
QTY
PARTS
QTY
MCW6000-P™ waterblock
1
Retention clips
2
Worm drive clamps
2
SP4 hold-down plate
1
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation
may result in damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of
these products, nor their installation. The following instructions are subject to change without notice. Please visit our web
for updates.
b
ITEM NO.
QTY. PART NO.
DESCRIPTION
1
1 S478
Intel Pentium 4 socket 478 motherboard and processor
2
1 MCW6000-P-with-bracket
MCW6000-P water-block assembly
a
1 MCW6000-FLAT
MCW6000 waterblock flat base
1 SP4-Bckt
SP4 Hold-down plate for Intel Pentium 4 and Xeon
3
2 SC478
Pentium 4 spring clip
3
1
INLET
DISCHARGE
Copyright Swiftech 2004 – All rights reserved – Last revision date: 4-19-04
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28
th
Street, Signal Hill, CA 90755 – Tel. 562-595-8009 – Fax 562-595-8769 - E
Mail: [email protected] – URL:
http://www.swiftnets.com
- Information subject to change without notice