Swiftech MCW5002 P User Manual
Parts list
Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Parts list
Parts
QTY
PARTS
QTY
MCW5002-P™ assembly
1
Arctic Alumina Thermal compound
1
½” Barb fittings
2
Retention clips
2
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in
damage to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their
installation. The following instructions are subject to change without notice. Please visit our web site at
updates.
1.
Preparing your Motherboard
Remove the existing heat sink
Carefully clean the CPU.
Lightly coat the CPU with the provided thermal compound. Only a paper-thin coat is necessary. It should be applied
using preferably a razor blade, or a credit card, held between thumb and index at a 45-degree angle.
2.
Install the hose barbs into the MCW5002 Housing.
Plastic barbs are provided with all the MCW5002 series water-blocks, please do not swap for brass barbs, as cell
corrosion WILL result.
Thread sealant must be used when making up the threaded connection. The best sealant is 'Plumber's Goop' but
Teflon tape can be used as well.
i. With Goop, fill the threads on the barb and screw in by rotating 1/2 turn forward, 1/4 turn back (this
will help work the Goop into the water-block's female threads). After 24 hrs the goop will be quite
solid.
ii. With Teflon tape, apply 3 to 4 wraps in a clockwise rotation with the threaded end facing you, then
screw into the water-block's female threads without any backwards rotation. The Teflon sealed
connection may be tested immediately.
When properly made up there will be ~3/16" of thread showing under the 'nut’ portion of the fitting.
3.
MCW5002-P™ water-block installation
The MCW5002-P water-block installs using Intel’s stock socket 478 retention frame. Installation procedure to the
motherboard is essentially the same as for the MCW5000 series water-blocks, pictures of which are shown
below.
Step 1
Position your block inside the
retention frame. Put both clips in
place for the next step, by simply
slipping the hook of each clip into
the holes of the retention frame.
Step 2
While maintaining the opposite
side of the block to prevent it from
tipping over, push down on the
clips’ thumb-tab until the hook
catches the hole in the retention
frame.
Step 3
Keep maintaining pressure on the
block to prevent it from tipping
over, and hook-down the second
clip.
Installation is complete!
Last revised 1-28-04 – copyright Swiftech