Swiftech MCW5000 A User Manual
Parts list
Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90755 T. (562) 595-8009 F. (562) 595-8769
Parts list
Parts
QTY
PARTS
QTY
MCW5000-A™ assembly
1
Arctic Alumina Thermal compound
1
Tube inserts
4
Tube removal tool
1
This product is intended for expert users. Please consult with a qualified technician for installation. Improper installation may result in damage
to your components. Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products, nor their installation. The
following instructions are subject to change without notice. Please visit our web site at
tes.
1.
Before you install the MCW5000-A™ water-block:
a. Prepare two pieces of tubing of sufficient length to connect
to the rest of your circuit. The cuts must be square as shown in
figure 1 or leaks may occur:
b. Install the provided plastic tube inserts at each end of the tubes,
as shown in figure 2: these inserts are absolutely imperative when
using any kind of soft tubing, such as vynil, ClearFlex, Taigon, etc...
Square cut
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
c. Spread a little bit of grease (Vaseline etc..)
around the tubing. It helps pushing the tubes in,
particularly with Clearflex
tubing, which
features a very “sticky” surface.
d. Fully insert both tubes into the fittings. The tip of the plastic tube inserts should
be flush with the inlet and outlet openings, as shown in figure 4 above. Inserting the
tubes requires a firm push, accompanied by a twisting motion.
2.
Preparing your Motherboard
a.
Remove the existing heat sink
b. Carefully clean the CPU.
c.
Lightly coat the CPU with the provided thermal compound. Only a paper-thin coat is necessary. It should be applied using
preferably a razor blade, or a credit card, held between thumb and index at a 45-degree angle.
3.
Installing the MCW5000-A™ water-block with AMD
socket 462 processors:
Follow steps on page 2.
Page 1 of 3