Swiftech MCR X20 DRIVE User Manual

Mcr “drive” series radiators

St., Long Beach, CA 90805

– Toll free (US) 888-857-9438 – Tel. (310) 763-0336, Fax (310) 763-7095 - E Mail: [email protected] – URL: http://www.swiftech.com -

Information subject to change without notice

MCR “DRIVE” series

radiators

INSTALLATION GUIDE

MCR220-DRIVE-B

MCR220-DRIVE

MCR320-DRIVE-B

MCR320-DRIVE

One or more patents pending

MCR DRIVE-B versions (without pump)

MCP350 or MCP355 pump installation

– skip this step if you have the MCR Drive with integrated pump version

Disassemble the MCP350 or MCP355 pump ports housing from the

main motor housing by loosening and removing all 4 screws. Reassemble the
pump body to the MCR drive radiator while making absolutely sure to keep
the existing pump o-ring in place or the assembly will leak! To assemble,
simply align the pump body with the MCR Drive pump housing, and fasten it
with the supplied 8-

32 x ¾” socket screws.

MCR220 and 320 Drive installation

1. Installation of the fittings:

The MCR Drive heat exchangers are shipped with 2 sets of fittings: ½”
(12mm) and 3/8” (10mm). Each set is composed of two different fittings: a
long fitting that screws into the radiator inlet

identified by an “IN” label, and a

short fitting that screws into the pump housing outlet

identified by an “OUT”

label.

Use a 5/8” (16mm) flat wrench or preferably a socket wrench to fasten

the fittings very tight to the radiator body so as to prevent leaks.

This manual is related to the following products:

MCR DRIVE