Swiftech APOGEE DRIVE II Pump installation User Manual

Swiftech Computer Accessories

310-763-0336 - Toll free (US) 888-857-9438

– Fax 310-763-7095 - E Mail: [email protected] – URL: http://www.swiftech.com - Information subject to change without notice

Please refer to specific model manuals for further installation & instructions for use.

1/ Pump body installation

Use the 4 provided screws to fasten your pump to the
housing body as shown below.

Critical precautions:



Make sure that the pump o-ring remains properly
sited in its groove.



Tighten the screws gradually and in a cross-pattern
until there is no gap left between the body of the
pump and the body of the waterblock housing.



Self-test: you should not be able to insert a sheet
of paper between the body of the pump and the
body of the waterblock once they are mated.

2/ Heatsink installation

Place the enclosed thermal pad (1) on the pump, align the
2 heatsink mounting holes with those of the pump, and then
fasten the heatsink with the provide screws. A small gap
equivalent to the thickness of about two sheets of paper will
subsist between the heatsink and the pump body, and this
is acceptable.