Swiftech MCW30 - Manual (Page 2)

Copyright Swiftech 2006 - All rights reserved - Last revision date: 1-17-06 - One or more Patents Pending
Rouchon Industries, Inc., dba Swiftech - 1703 E. 28th Street, Signal Hill, CA 90755 - Tel. 562-595-8009 - Fax 562-595-8769 -
E Mail: [email protected] - URL: http://www.swiftnets.com - Information subject to change without notice
ITEM
PART NUMBER DESCRIPTION QTY
.
1 MCW30-base-plate 1
2 MCW30-HOUSING 1
3 92196A109 4-40 x 7/16" S/S socket screw 4
4 1-4-NPSMx3-8-barb 1/4" NPSM X 3/8" Barb fitting 2
5 O-RING-9557K473 1-4'" NPSM barb fitting O-Ring 2
7 board-mockup 1
8 MCW30-bracket2 2
9 70700S spring 2
10 SCREW INSULATOR10SC004025 2
11 4-40x1-25-philips-91400A124 4-40 x 1.25 philips screw 2
12 KNURLED NUT 0800440TN 2
13 4-40-nut 2
14 4-40-fiberwasher 4
12
10
9
13
14
4
5
14
11
8
2
1
7
3
Installation with AMD compatible motherboards
•
Removal of the mother-
board is necessary to install
the mountings posts
•
Remove the existing
heatsink
•
Install the two mounting
posts 11 as shown in the
schematic and fasten them
with the nuts 13 and washes
14.
•
Clean off the CPU with
a degreaser, and spread some
of the included thermal com-
pound over it.
•
Install the MCW30 over
the CPU
•
Install the springs 9, ten-
sion limiters 10, and knurled
knobs 12
•
Gradually and alterna-
tively fasten the knobs until the
proper tension is reached: an
equal amount of tension is
provided by the tension lim-
iters. Do not overtighten the
knobs!
•
Installation is now com-
plete.