Swiftech SLI/Crossfire bridges for MCW60/80/82 - Manual (Page 2)

Step 4: Attach the bridge to each graphics card
Slip the loose clamps over the tubes, and then push each
graphics card into the bridge fittings. Finally, fasten the clamps.
Step 5: Install the cards back into your motherboard, and
complete the connections to the rest of your loop.
ALWAYS TEST YOUR BLOCKS FOR LEAKS PRIOR TO POWERING UP YOUR SYSTEM!
DISCLAIMER: While all efforts have been made to provide the most comprehensive tutorial possible, Swiftech® assumes no liability
expressed or implied for any damage(s) occurring to your components as a result of using Swiftech® cooling products, either due to mistake or
omission on our part in the above instructions, or due to failure or defect in the
Swiftech® cooling products. In addition, Swiftech™ assumes no liability,
expressed or implied, for the use of this product, and more specifically for any, and all damages caused by the use of this product to any other device in
a personal computer, whether due to product failure, leak, and electrical short, and or electro-magnetic emissions. WARRANTY: Our products are
guaranteed for 12 months from the date of delivery to the final user against defects in materials or workmanship. During this period, they will be repaired
or have parts replaced provided that: (I) the product is returned to the agent from which it was purchased; (II) the product has been purchased by the
end user and not used for hire purposes; (III) the product has not been misused, handled carelessly, or other than in accordance with any instructions
provided with respect to its use. This guarantee does not confer rights other than those expressly set out above and does not cover any claims for
consequential loss or damage. This guarantee is offered as an extra benefit and does not affect your statutory rights as a consumer.