Allied Telesis AT-S39 - Manual (Page 158)

Chapter 18: TACACS+ and RADIUS Commands
158
quietperiod Sets the number of seconds that the switch remains in
the quiet state following a failed authentication
exchange with the client. The default value is 60
seconds. The range is 0 to 65,535 seconds.
txperiod Sets the number of seconds that the switch waits for a
response to an EAP-request/identity frame from the
client before retransmitting the request. The default
value is 30 seconds. The range is 1 to 65,535 seconds.
reauthperiod Enables periodic reauthentication of the client, which
is disabled by default. The default value is 3600
seconds. The range is 1 to 65,535 seconds.
supptimeout Sets the switch-to-client retransmission time for the
EAP-request frame. The default value for this
parameter is 30 seconds. The range is 1 to 600
seconds.
servtimeout This is the timer used by the switch to determine
authentication server timeout conditions. The default
value for this parameter is 30 seconds. The range is 1
to 65,535 seconds.
maxreq This parameter specifies the maximum number of
times that the switch retransmits an EAP Request
packet to the client before it times out the
authentication session. The default value for this
parameter is 2 retransmissions. The range is 1 to 10
retransmissions.
Description
This command is a client-server-based access control and authentication
protocol that restricts unauthorized clients who attempt to connect to a
network through accessible, local ports. When Port Access Control is
enabled, the authentication server authenticates each client connected
to a port before making available the network or any services offered by
the switch. This command allows you to set port access control
parameters.
Examples
To set a port’s role as Authenticator, type the following:
set portaccess port=1 role=authenticator
To set all ports with the Authenticator role, type the following: