Allied Telesis AT-S39 - Manual (Page 113)

AT-S39 Command Line Interface User’s Guide
113
SET SWITCH VLANMODE
Syntax
set switch vlanmode=userconfig|multiple|
dotqmultiple
Parameters
vlanmode Specifies the switch’s VLAN mode. Specifying
USERCONFIG means the switch will support port-
based and tagged VLANs. Specifying MULTIPLE means
the switch will support the non-801.Q compliant
multiple VLANs mode. Specifying DOTQMULTIPLE
means the switch will support the 801.Q compliant
multiple VLANs mode. The default is USERCONFIG.
Description
This command configures the switch’s VLAN Mode to user-configured
(port-based and tagged) VLANs or multiple (non-801.Q compliant and
801.Q compliant) VLAN mode.
Example
The following command configures the switch to support 801.Q
compliant VLAN mode:
set switch vlanmode=dotqmultiple