Allied Telesis AT-S39 - Manual (Page 115)

AT-S39 Command Line Interface User’s Guide
115
CREATE VLAN
Note
This command is only allowed in user-configured VLANs mode. If
you use this command when in multiple VLAN mode, you will
receive the following message:
Operation NOT allowed in Multiple VLANs mode
Syntax 1
create vlan=name vid=vid ports=ports|ALL
frame=untagged|tagged [mirrorport=mirrorport]
Syntax 2
create vlan=name vid=vid
taggedports=taggedports|ALL
untaggedports=untaggedports|ALL
[mirrorport=mirrorport]
Parameters
vlan Specifies the name of the VLAN. A VLAN must be
assigned a name.
The name can be from one to ten characters in
length. The name should reflect the function of the
nodes that will be a part of the VLAN (for example,
Sales or Accounting). The name cannot contain
spaces or special characters, such as asterisks (*) or
exclamation points (!).
The name cannot be the same as the name of an
existing VLAN on the switch.
If the VLAN will be unique in your network, then the
name should be unique as well. If the VLAN will be
part of a larger VLAN that spans multiple switches,
then the name for the VLAN should be the same on
each switch where nodes of the VLAN are
connected.
vid Specifies the VLAN identifier. The range is 2 to 4094.
The VLAN must be assigned a VID.
You cannot use the VID 1; that value is reserved for
the Default VLAN.
The VID cannot be the same as the VID of an existing