Allied Telesis AT-S39 - Manual (Page 122)

Chapter 13: VLAN Commands
122
DELETE VLAN
Note
This command is only allowed in user-configured VLANs mode. If
you use this command when in multiple VLAN mode, you will
receive the following message:
Operation NOT allowed in Multiple VLANs mode
Syntax 1
delete vlan=name|vid ports=ports
frame=untagged|tagged [mirrorport=mirrorport]
Syntax 2
delete vlan=name|vid taggedports=taggedports
untaggedports=untaggedports
[mirrorport=mirrorport]
Parameters
vlan Specifies the name or VID of the VLAN from which
ports are to be removed.
ports Specifies the ports to be removed from the VLAN.
This parameter must be used with the FRAME
parameter.
frame Specifies whether the ports to be removed are
tagged or untagged.
taggedports Specifies the tagged ports on the switch that you
want to remove from the VLAN. You can specify the
ports individually (e.g., 2,3,5), as a range (e.g., 7-9), or
both (e.g., 2,5,7-9). Specifying ALL removes all
tagged ports from the VLAN.
untaggedports Specifies the untagged ports on the switch that you
want to remove from the VLAN. You can specify the
ports individually (e.g., 2,3,5), as a range (e.g., 7-9), or
both (e.g., 2,5,7-9). Specifying ALL removes all
untagged ports from the VLAN.
mirrorport The port on the switch which you want to have stop
functioning as a mirror port of the VLAN.