Allied Telesis AR400 Series Router - Manual (Page 126)

126 AR400 Series Router User Guide
Software Release 2.6.1
C613-02021-00 REV D
Resetting Router Defaults
To restart the router at any time with no configuration, enter the command:
RESTART ROUTER CONFIG=NONE
If boot.cfg has changed, to set it back to the default configuration by saving
the default dynamic configuration to the boot.cfg file, enter the command:
CREATE CONFIG=boot.cfg
To set the router to restart with the boot configuration file, enter the command:
SET CONFIG=boot.cfg
DO NOT clear the FLASH memory completely. The software release files are
stored in FLASH, and clearing it would leave no software to run the router.
Checking Connections Using PING
If an aspect of the router’s configuration dependent on access to a server
functions incorrectly, PINGing the server from the router, and the router from
the server, is a useful first step in diagnosis.
You can use PING (Packet Internet Groper) to check whether there is a
connection between the router and another routing interface in the network.
Use the router’s extended PING command over IPv4, IPv6, IPX, AppleTalk,
and OSI network protocols. PING sends echo request packets in the chosen
format, and displays responses at the terminal. Enter the command:
PING [{[IPADDRESS=]ipadd|[IPXADDRESS=]network:station|
[APPLEADDRESS=]network.node|[OSIADDRESS=]nsap}]
[LENGTH=number] [NUMBER={number|CONTINUOUS}]
[PATTERN=hexnum]
[{SIPADDRESS=ipadd|SIPXADDRESS=network:station|
SAPPLEADDRESS=network.node|SOSIADDRESS=nsap}]
[SCREENOUTPUT={YES|NO}] [TIMEOUT=number] [TOS=number]
To set PING defaults, enter the command:
SET PING [{[IPADDRESS=]ipadd|[IPXADDRESS=]network:station|
[APPLEADDRESS=]network.node|[OSIADDRESS=]nsap}]
[LENGTH=number] [NUMBER={number|CONTINUOUS}]
[PATTERN=hexnum]
[{SIPADDRESS=ipadd|SIPXADDRESS=network:station|SAPPLEADDR
ESS=network.node|SOSIADDRESS=nsap}]
[SCREENOUTPUT={YES|NO}] [TIMEOUT=number] [TOS=number]
To display the default PING settings and summary information, enter the
command:
SHOW PING
The stop a PING that is in progress, enter the command:
STOP PING
If you can PING the end destination, then the physical and layer 2 links are
functioning, and any difficulties are in the network or higher layers.