Allied Telesis AR400 Series Router User Manual
Page 104
104
AR400 Series Router User Guide
Software Release 2.6.1
C613-02021-00 REV D
4.
Configure PPP.
To configure a PPP interface over the ISDN interface, enter the command:
CREATE PPP=0 OVER=ISDN-DVMRP IDLE=ON
5.
Configure IP.
To enable the IP module, and assign IP addresses to the interfaces, enter the
commands:
ENABLE IP
ADD IP INTERFACE=FR0 IPADDRESS=202.96.152.12
MASK=255.255.255.0
ADD IP INTERFACE=PPP0 IPADDRESS=203.45.90.3
MASK=255.255.255.0
ADD IP INTERFACE=ETH0 IPADDRESS=172.74.2.3
MASK=255.255.255.0
6.
Configure IGMP.
To enable IGMP on the router and on the interfaces over which group
membership is to be managed, enter the commands:
ENABLE IP IGMP
ENABLE IP IGMP INTERFACE=ETH0
ENABLE IP IGMP INTERFACE=PPP0
ENABLE IP IGMP INTERFACE=FR0
7.
Configure DVMRP.
Enable DVMRP on the router, and assign the interfaces over which
DVMRP will perform multicast routing. Enter the commands:
ENABLE DVMRP
ADD DVMRP INTERFACE=ETH0 METRIC=1
ADD DVMRP INTERFACE=PPP0 METRIC=3
ADD DVMRP INTERFACE=FR0 DLC=20 METRIC=6
Configure multicast routing using DVMRP on Router D.
1.
Set the system name.
To set a unique system name for the router, enter the command:
SET SYS NAME=D-dvmrp
2.
Configure Frame Relay.
To create a Frame Relay interface over a synchronous port to Router C, and
add a data link circuit to the Frame Relay interface, enter the command:
CREATE FR=0 OVER=SYN0 LMI=NONE
ADD FR=0 DLC=20
3.
Configure IP.
To enable IP, and assign IP addresses to the interfaces, enter the commands:
ENABLE IP
ADD IP INTERFACE=ETH0 IP=172.70.1.2 MASK=255.255.255.0
ADD IP INTERFACE=FR0 IP=202.96.152.4 MASK=255.255.255.0