Allied Telesis AT-8088/xx (MT and SC) User Manual
Installation guide
This manual is related to the following products:
Table of contents
Document Outline
- Electrical Safety and Emission Statement
- Contents
- Preface
- Chapter 1
- Overview
- Common Features
- Model Descriptions
- Hardware Features
- 100Base-FX Fiber Optic Ports
- 10/100Base-TX Twisted Pair Ports
- 10/100/1000Base-T Twisted Pair Ports
- Gigabit Interface Converter (GBIC) Expansion Slots
- Module Expansion Slots
- Twisted Pair Port LEDs and the LED Mode Select Button
- Fiber Optic Port LEDs
- System LEDs
- RS-232 Terminal Port
- Reset Button
- RPS Connector
- AC Power Connector
- DC Power Connector
- A Few Basics about Ethernet Switching
- Network Topologies
- Chapter 2
- Installation
- Reviewing Safety Precautions
- Selecting a Site for the Switch
- Planning the Installation
- Unpacking the Switch
- Installing the Switch in a Rack
- Installing an Optional GBIC Module
- Installing an Optional Expansion or Stacking Module
- Installing an Optional AT-RPS3004 Redundant Power Supply
- Cabling and Powering ON the Switch
- Wiring a DC Powered Unit
- Starting a Local Management Session
- Warranty Registration
- Chapter 3
- Troubleshooting
- Appendix A
- Technical Specifications
- Physical Specifications
- Environmental Specifications
- Power Specifications
- Safety and Electromagnetic Emissions Certifications
- Standards
- SNMP Support
- RJ-45 Twisted Pair Port Pinouts
- RS-232 Terminal Port Pinouts
- RPS 16-pin Molex Connector Port Pinouts
- MT-RJ Connector
- SC Type Connector
- ST Type Connector
- HSSDC Connector
- AT-8016F/xx, AT-8026FC, and AT-8088/xx Fiber Optic Port Specifications
- Appendix B
- Translated Electrical Safety and Emission Information