Allied Telesis AT-FS202SC/FS4 - Manual (Page 32)

22
Standards: This product meets the following standards.
$
1 RFI Emission EN55022 Class A
$
2 Warning: In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
$
3 Immunity EN55024
$
4 Warning: This product requires shielded cables to comply with emission and
immunity standards. If it is used with unshielded cables, the user may be required
to take measures to correct the interference problem at their own expense.
$
5 Electrical Safety EN60950, UL1950, CSA 950
$
6 Laser EN60825
$
7 Warning Class 1 Laser product.
$
8 Warning Do not stare into the Laser beam.
At time of installation, the Fiber Optic Lasers comply with FDA Radiation
Performance Standard 21CFR Subchapter J, applicable at date of manufacture.
$
9 This is a “CLASS 1 LED PRODUCT” (AT-FS201, AT-FS202, AT-FS203 models)
Safety
$
10 Lightning Danger
Danger: DO NOT WORK on equipment or CABLES during periods of LIGHTNING
ACTIVITY.
$
11 DO NOT BLOCK AIR VENTS
$
12 Power to the hub must be sourced only from the adapter.
USA/Canada
Use a UL Listed/CSA Certified AC adapter of DC 12V, 500mA.
Europe - EU
Use TÜV licensed AC adapter of DC 12V, 500mA.
UK
Use a UK Safety Approved AC adapter of DC 12V, minimum 500mA.
$
13 Operating Temperature
This product is designed for a maximum ambient temperature of 40 degrees C.
$
14 All Countries : Install product in accordance with local and National Electrical
Codes.
U.S. Federal Communications Commission
RADIATED ENERGY
Note: This equipment has been tested and found to comply with the limits for a
Class A digital device pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with this instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct
the interference at his own expense.
Note: Modifications or changes not expressly approved of by the manufacturer or
the FCC, can void your right to operate this equipment.
Industry Canada
This Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement
sur le matériel brouilleur du Canada.