Allied Telesis AT-VIEW PLUS 3.0 AMIGO - Manual (Page 25)

Allied Telesyn AT-VIEW PLUS
AMIGO
4.1.6.1 Setting MIB-Files Tab
In the Setting MIB-Files tab, you can specify which MIB files AMIGO uses to draw the MIB tree.
To add a MIB file, enter a file name in the MIB-File name textbox then click Add or select a MIB
file using the Browse button. To remove a MIB file, select a file from the list then click Delete.
Auto Add
Using the "Auto Add" button, you can automatically add the MIB files which are required to
manage the target device. When you click "Auto Add", MIB files which are needed by the
target hosts specified in the "Setting target devices" tab are added to the MIB files list.
You can automatically add MIB files only if the target device is supported by AT-View Plus.
Select MIB-Files tab
4.1.6.2 Setting Target Devices Tab
In the "Setting target devices" tab, you can add or remove a target device to/from which MIB values
are set or retrieved. You can also configure the SNMP connection properties of a target device.
PN 613-50662-00 Rev A Page 25 of 43
To add a target device, input a dotted IP address or a host name in the Host name textbox, then click
Add.