beautypg.com

Removing the at-mcf2000s stacking module – Allied Telesis AT-MCF2000S User Manual

Page 28

background image

Chapter 1: Installation

28

Removing the AT-MCF2000S Stacking

Module

To remove the AT-MCF2000S Stacking Module, perform the
following procedure:

1.

Remove all cables from ports on the module.

2.

Using a cross-head screwdriver, loosen the two captive
screws that secure the module to the chassis.

3.

Slide the module from the chassis.

Caution

The AT-MCF2000S Stacking Module is sensitive to and can
be damaged by electrostatic discharge. When installing the
module in the chassis, wear a grounding device and observe
electrostatic discharge precautions.

4.

If you are not replacing the module, reinstall the blank panel
over the management slot.

Note

Do not leave a chassis slot open. An open slot allows dust to
enter the chassis and reduces the airflow and cooling of
components.

5.

If you are replacing the module, begin the installation of the
new stacking module with “Verifying the Package Contents”
on page 15.