Allied Telesis AT-MCF2000S - Manual (Page 15)

AT-MCF2000S Stacking Module Installation Guide
15
ˆ An LED display shows the chassis ID of the stacking module.
ˆ A set of DIP switches located on the top of the module permits
you to set the chassis ID. For the stacking module, the range
of chassis ID is from 1 to 30.
Verifying the Package Contents
Make sure the following items are included in your package. If any
item is missing or damaged, contact your Allied Telesis sales
representative for assistance.
ˆ An AT-MCF2000S Stacking Module
ˆ This installation guide
Cable Requirements
The cable requirements for the STACK 1 and STACK 2 ports on
the AT-MCF2000S Stacking Module are provided here:
ˆ Standard straight-through or crossover TIA/EIA 568-A-
compliant Category 5 or TIA/EIA 568-B-compliant Enhanced
Category 5 (Cat 5e) shielded or unshielded cabling with 100
ohm impedance.
ˆ Standard 8-pin RJ-45 connectors
ˆ Maximum length of 100 meters (328 feet)