Allied Telesis AT-MCF2000S - Manual (Page 19)

AT-MCF2000S Stacking Module Installation Guide
19
Note
Do not remove the blank panel from the chassis until you are
ready to install a module. An open slot allows dust to enter
the unit and hinders the ability of the chassis to maintain
proper airflow and cooling.
3. Remove the tape from the DIP switch.
4. Set the chassis ID of the stacking module. Use the tip of a
ballpoint pen to change the setting of the DIP switch. See
Figure 3 on page 20. The chassis ID can be from 1 through
30. The default value is 1.
Use the table of DIP switch settings that is printed on the
module to determine the new chassis ID. Use the switches
labeled 1 through 5.
Caution
You cannot use the switch labeled 6.