Allied Telesis AT-MCF2000S - Manual (Page 23)

AT-MCF2000S Stacking Module Installation Guide
23
If this is the last chassis in the stack, you can connect the
stacking cable to either port. For cabling guidelines, see the
next section.
Cabling a Media Converter Stack
To create a stack of media converters, you daisy-chain the units
with the Stack ports. The Stack port on the AT-MCF2000M
Management Module must be connected to the STACK 1 or
STACK 2 port on the AT-MCF2000S Stacking Module in the next
chassis.
Connect the remaining Stack port on the stacking module to the
STACK 1 or STACK 2 port in the next chassis, and so on. Loops
and redundant connections are not supported. For cable
specifications, see “Cable Requirements” on page 15.
To cable a media converter stack, perform the following
procedure:
1. To connect the AT-MCF2000M Management Module to the
AT-MCF2000S Stacking Module, connect the Stack port on
the management module to either the STACK 1 or STACK 2
port on the stacking module. See Figure 7 on page 24.