Show vrrp command information – Allied Telesis AT-S63 User Manual
Page 620

Chapter 35: Virtual Router Redundancy Protocol (VRRP) Commands
620
Section II: Advanced Operations
The information in the display is described in Table 23.
Table 23. SHOW VRRP Command Information
Section
Parameter
Description
Virtual Router Identifier
Virtual router identifier.
Configuration
VR MAC Address
Virtual router’s MAC address, derived from
the virtual router identifier.
Interface
LAN interface that the virtual router is
operating on.
Priority
Priority of the switch for assuming the master
role for the virtual router.
State
Current status of the switch in the virtual
router which may be master, backup, or initial.
Initial indicates that either the virtual router or
VRRP is disabled.
Authentication
If the virtual router uses no authentication or
plaintext or HMAC authentication.
Password
Whether or not the password is set.
IP Address(es)
Shows the IP addresses associated with the
virtual router.
Advertisement Interval
Period in seconds between advertisement
packets.
Preempt Mode
Whether preempt mode is on. When on, the
switch determines whether a higher priority
switch assumes the master role over one with
lower priority.
Preempt Delay
(seconds)
Period in seconds that the switch delays
before assuming the master role after it has
determined that its priority is greater than all
other switches. Valid only when preempt
mode is on.
Original Priority
The original priority of the port before being
affected by either the port monitoring or
monitored interface feature.
Port Monitoring
Whether the port monitoring feature is on.
This parameter is displayed only when the
virtual router operates over a VLAN interface.