Allied Telesis AT-S63 User Manual

Page 371

AT-S63 Management Software Command Line User’s Guide

Section III: Snooping Protocols

371

static MAC addresses. The range is 1 to 255
addresses; the default is 64 addresses.

Note

The combined number of multicast address groups for IGMP and
MLD snooping cannot exceed 255.

routerport

Specifies the port(s) on the switch
connected to a multicast router. Options are:

port

Specifies the router port(s)

manually.

all

Specifies all of the switch ports.

none

Sets the mode to manual

without any router ports
specified.

auto

Activates auto-detect, where

the switch automatically
determines the ports with
multicast routers.

Description

This command configures the MLD snooping parameters.

Examples

The following command activates MLD snooping, sets the MLD topology
to Multi-Host, and sets the timeout value to 120 seconds:

set ipv6 mldsnooping snoopingstatus=enabled
hoststatus=multihost timeout=120

The following command changes the topology to Single-Host:

set ipv6 mldsnooping hoststatus=singlehost

The following command disables MLD snooping:

set ipv6 mldsnooping snoopingstatus=disabled

Equivalent Commands

disable mldsnooping

enable mldsnooping