Allied Telesis AT-S63 - Manual (Page 584)

Chapter 33: Internet Protocol Version 4 Packet Routing Commands
584 Section VII: Internet Protocol Routing
SHOW IP COUNTER
Syntax
show ip counter [port= ports |all]
Parameters
port Specifies the ports whose IP statistics are to be
displayed. You can specify the ports individually (for
example, 5,7,22), as a range (for example, 18-23), or
both (for example, 1,5,14-22). Omitting this parameter
displays the statistics for all ports.
Description
This command displays Layer 3 counters for the individual ports on a
switch. Figure 48 is an example of the information displayed by this
command.
Figure 48. SHOW IP COUNTER Command
The lines in the display are:
ˆ IPInUcastPkts - Number of IP packets received on a port.
ˆ IPOutUcastPkts - Number of IP packets transmitted from a port.
ˆ IPInDiscards - Number of IP packets received but discarded due to
resource limitations at the IP level.
ˆ IPInHdrErrors - Number of IP packets received with header errors.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
Port 1
IPInUcastPkts ................... 0
IPOutUcastPkts .................. 0
IPInDiscards .................... 0
IPInHdrErrors ................... 0
Port 2
IPInUcastPkts ................... 0
IPOutUcastPkts .................. 0
IPInDiscards .................... 0
IPInHdrErrors ................... 0