Allied Telesis AT-S87 - Manual (Page 86)

Chapter 8: Class of Service (CoS)
86
Mapping CoS Priorities to Egress Queues
This procedure explains how to change the default mappings of CoS
priorities to egress priority queues, shown in Table 3 on page 83. This is
set at the switch level. You cannot set this at the per-port level.
To change the CoS priority mappings, perform the following procedure.
1. From the main menu, select Bridge > CoS.
The CoS page is shown in Figure 27.
Figure 27. CoS Page
2. For each priority whose queue you want to change, select a queue in
the CoS Queue list.
3. Do one of the following:
ˆ Click OK to save the changes.
ˆ Click Reload to clear the changes and start over.
4. To permanently save these settings in the configuration file, from the
main menu, select Save Configuration.
The Save Configuration page is shown in Figure 3 on page 21.
5. Click Save.