Allied Telesis AT-S87 - Manual (Page 34)

Chapter 3: Port Configuration
34
Enabling or Disabling a Port
To enable or disable a port, perform the following procedure:
1. From the main menu, select Physical Interface.
The Physical Interface page is shown in Figure 9.
Figure 9. Physical Interface Page
2. In the Port List, select the port you want to configure, or scroll through
the list below.
The port is highlighted in the port list.
3. In the Admin list, select Enabled or Disabled.
4. Click Modify.
The Admin status shown in the table for that port is changed. Continue
to select and modify other ports as necessary.
5. Do one of the following:
ˆ Click OK to save the changes.
ˆ Click Reload to clear the setting and start over.
6. To permanently save these settings in the configuration file, from the
main menu, select Save Configuration.
The Save Configuration page is shown in Figure 3 on page 21.
7. Click Save.