Allied Telesis AT-S87 - Manual (Page 55)

AT-S87 Management Software User’s Guide
55
Removing a Trunk
To remove a port trunk, perform the following procedure:
1. From the main menu, select Bridge > Trunking.
The Trunking page is shown in Figure 15 on page 52.
2. In the Show Trunk list, select the trunk you want to remove.
3. Check the Remove Trunk box.
4. Click OK.
5. To permanently save these settings in the configuration file, from the
main menu, select Save Configuration.
The Save Configuration page is shown in Figure 3 on page 21.
6. Click Save.