Allied Telesis AT-2912T - Manual (Page 35)

AT-2712FX/SC and AT-2912T Secure Ethernet Network Adapter Installation and User’s Guide
35
Setting Vista’s Next Generation TCP/IP Stack
After you install an Allied Telesis AT-2712FX/SC or AT-2912T adapter in
your PC, the system detects the new hardware automatically when the
Windows Vista Operating system first boots up. You are prompted to
install the driver software for that device shortly after you log in. To update
the driver software, you must have administrative privileges.
Note
The adapter must be physically installed in your system before you
install the driver software. See Chapter 2, “Installing the Hardware”
on page 21 for instructions.
To set the Next Generation TCP/IP Stack of the Vista Operating System,
do the following:
1. Start a Windows Vista Operating system and log in.
You must have Administrator privileges to update the driver software.
2. The Found New Hardware page is displayed on your personal
computer.
The Found New Hardware page is shown in Figure 11.
Figure 11. Found New Hardware Page