Allied Telesis AT-2912T - Manual (Page 27)

AT-2712FX/SC and AT-2912T Secure Ethernet Network Adapter Installation and User’s Guide
27
Installing a Network Adapter Card
The following instructions apply to installing both the AT-2712FX/SC and
AT-2912T adapters in most systems. For details about performing these
tasks on your particular system, refer to the manuals that were supplied
with your system.
Note
To perform this procedure, you need to supply a Phillips-head
screw.
To install an AT-2712FX/SC or AT-2912T adapter, perform the following
procedure:
1. Review the “Pre-Installation Checklist” on page 24 and “Reviewing
Safety Precautions” on page 22.
Before installing the adapter, ensure the system power is OFF and
unplugged from the power outlet, and that proper electrical grounding
procedures have been followed.
Warning
High voltage inside the system presents a safety hazard. Make sure
the power is off before removing the cover.
2. Remove the system cover and select any appropriate empty PCI slot.
See Figure 7 on page 28.
If you do not know how to identify an appropriate PCI slot, refer to your
system documentation.