Allied Telesis AT-WNP300N - Manual (Page 22)

22 AT-WNP300N - IEEE802.11b/g/n 1T2R Wireless Fast PCI adapter - User Manual
4. Click on “OK”.
5. In “Profile” tab, select the profile you want to connect to, and then click on “Activate”.
Figure 21: Active an Un-secured Network
Connect to a WEP Network
Please perform the following procedure to connect to a WEP network.
1. In “Network” tab, select the AP you want to connect to, and then click on “Add to Profile”.
Figure 22: Select a Network
2. In “System Config” tab, give the profile a name to identify.
Figure 23: Configure Profile
3. In “Auth.\Encry.” tab, confirm that the Authentication and Encryption setting is corresponding to the
wireless AP. Input the Key and then click on “OK” to apply the settings.
Figure 24: Configure Auth./Encry.
4. In “Profile” tab, select the profile you want to connect to, and then click on “Activate”.