Allied Telesis AT-2716POE User Manual
Page 73
AT-2716POE Fast Ethernet Fiber & PoE Adapter Installation and User’s Guide
73
1. In Microsoft Windows, right-click the Network Adapter in
Network Connections and then click Properties.
2. Click the Configure button and then the Advanced tab.
3. Set the Priority & VLAN setting to Priority & VLAN Disabled,
Priority & VLAN Enabled, Priority Enabled, or VLAN Enabled.
The default setting is Priority & VLAN Enabled.
Updating the Receive
Side Scaling property
The “Receive Side Scaling” Property allows for scaling the network
processing load across multiple processors.
1. In Microsoft Windows, right-click the Network Adapter in
Network Connections and then click Properties.
2. Click the Configure button and then the Advanced tab.
3. Set the "Receive Side Scaling" parameter to Disable or Enable.
The default setting is Enabled.
Updating the RSS
Queues property
The “RSS Queues” property allows configuring RSS queues from 1 to
4. Options are RSS 1 Queue, RSS 2 Queue, and RSS 4 Queue.
1. In Microsoft Windows, right-click the Network Adapter in
Network Connections and then click Properties.
2. Click the Configure button and then the Advanced tab.
3. Set the RSS queues to RSS 1 Queue, RSS 2 Queues, or RSS 4
Queues.
The default setting is RSS 4 Queues.
Updating the Speed
& Duplex property
The “Speed & Duplex” property allows for configuring the connection
speed and duplex of the device.
1. In Microsoft Windows, right-click the Network Adapter in
Network Connections and click Properties.
2. Click the Configure button and then the Advanced tab.
3. Set the speed to 10 Mb Full, 10 Mb Half, 100 Mb Full, 100 Mb
Half, or Auto.
The default setting for fiber is 100 Mb Full.
The default setting for copper is Auto.
Updating the
TCP/UDP Checksum
Offload (Ipv4)
property
The “TCP/UDP Checksum Offload (IPv4)” property allows configuring
checksum offload for the IPv4 protocol.
1. In Microsoft Windows, right-click the Network Adapter in
Network Connections and then click Properties.
2. Click the Configure button and then the Advanced tab.
3. Set the " TCP/UDP Checksum Offload (Ipv4)" parameter to
Disable, RX & TX Enabled, RX Enabled, or TX Enabled
The default setting is RX & TX Enabled.