Allied Telesis AT-2716POE - Manual (Page 22)

AT-2716POE Fast Ethernet Fiber & PoE Adapter Installation and User’s Guide
22
Installing a Network Adapter Card
The following instructions apply to installing an AT-2716POE adapter in
most systems. If you need more information, refer to the manuals that
were supplied with your system for details about performing these tasks
on your particular system.
Note
To perform this procedure, you need to supply one Phillips-head
screw.
To install the network adapter card, perform the following procedure:
1. Review the “Pre-Installation Checklist” on page 21 and Reviewing
Safety Precautions” on page 18.
Before installing the adapter, ensure the system power is OFF and
unplugged from the power outlet, and that proper electrical grounding
procedures have been followed.
Warning
High voltage inside the system presents a safety hazard. Make
sure the power is off before removing the cover.
2. Remove the system cover. See Figure 3.
Figure 3. Removing the PC Cover