beautypg.com

Connect the scanner to your computer – Epson 1200S User Manual

Page 19

background image

12

Connect the Scanner to Your Computer

Before you begin, make sure the scanner, computer, and any

SCSI devices connected to your computer are turned off. The

scanner is off when the

P

operate button is out (not pushed

down below the surface of the panel).

1. Locate the SCSI cable that came with your scanner.
2. Squeeze the lock releases on the cable connector and plug the cable into either

SCSI connector on the back of the scanner. The cable is secure when both

connector locks snap in. Then connect the other end to the SCSI port on your

computer or another SCSI device in the chain, and tighten the screws to secure

the cable.

If you are using a cable other than the one provided, the

length of the cable must not exceed 9.8 feet (3 meters). If you

are connecting multiple SCSI devices, the total length of the

SCSI bus (cables) must not exceed 19.7 feet (6 meters);

otherwise the system may not work properly