Epson 1200S - Manual (Page 16)

9
Install the SCSI Interface Board
You must install your SCSI board before installing the scanner driver and software
applications. If you have a Macintosh with a SCSI interface, or if you already have a
SCSI board installed in your PC, skip this section.
For additional installation information, see your computer
documentation.
1. Turn off the computer and any peripheral devices. Unplug any power cords; then
disconnect all cables from the back panel of your computer.
2. Remove the cover from your PC, or open up your Power Macintosh G3.
Static electricity can damage electronic components. Ground
yourself before you touch any of the computer’s internal
components by touching an unpainted metal surface inside
the computer case.
3. Remove the slot cover from an empty PCI expansion slot in your computer. (See
your computer documentation for information about your PCI slots.)
4. Insert the interface board into the slot; then secure
it with the bracket screw.
5. Replace the computer cover and reconnect all
cables.
Once you install the SCSI board, continue with the
following section, “Unlock the Scanner.”
bracket screw